Nodal Analysis

Nodal Analysis


Here is a picture of our circuit diagram.  Our value for v1 was 2.43 V and for v2 was 4.43 . 

 Here is the voltage we got for v1. We were pretty off our calculated value
Here is the V for our v2. Same for this voltage our values were off compared to our prelab values we calculated.

















Here is a picture of our schematic. I'm assuming we did not calculate our values properly.

Comments

Post a Comment

Popular posts from this blog

Dependent Sources and MOSFETs

Image
Dependent Sources and MOSFETs  I didn't take a pic of the DMM with the true value of the resistor, but it's value was 98.9 ohms. Pictured is the diagram of the circuit Here is the table for the V vs I. Our threshold voltage was 13.7 V. The transistor is behaving like a voltage dependent source, because changing the voltage changes the current.  here is the plot of data, with a calculated value for g which is 7.157 Ohms. I calculated this value by finding the slope of the data.                                    Here is a picture of our breadboard                 
Read more

Summing Amplifier

Image
 Here is a pic of our pre lab, we chose 22kOhms for our resistors. The actual values however were, R1=21.5kOhm, R2=21.7kOhm R3=21.4kOhm. Since our R values should betheoretically equal, our Vout equation should be Vout=-(Va+Vb). Our values made since except for Va=1, the value should've been -1V but it was -1.94V. For the last two values the %error was huge because of the saturation of the Op-Amp. Here are our experimental values from our board  Here's our circuit
Read more